Mixing Instruction
• Always use clean tools.
• Do not mix with residues of previously used compounds.
• The inclusion of such materials will impair the performance of this
product and will void the product warranty.
• USG Boral Premium Premix may appear thick in pail. Before adding
water. Lightly mix & test its application; if required. Add water to achieve
desired consistency.
• Caution: Avoid over-thinning when adding water as this may cause
cracking and excessive shrinkage.
• If liquid has separated from the compound, stir carefully to restore consistency.
• Caution: Do not overmix; overmixing can introduce air bubbles. which
can create surface imperfections.

Application Instruction
• Surfaces must be clean and free from dust.
• USG Boral Premium Premix may have high viscosity in the pail; it may be
diluted to a workable viscosity by adding water followed by mechanical mixing.
• Can be applied by hand or mechanical tools.
• When using USG Boral Premium Premix for all three coats, the first coat
must be used to bed a high-quality paper tape.
Directions - Jointing and Finishing
First Coat (150mm wide)
1. Cover joint with a thin layer of compound and embed paper tape. Leaving
at least 1mm of compound under feathered edge. Let dry and sand lightly.
Second Coat (200mm wide)
2. Apply second coat, feathering approximately 50mm beyond first coat.
Let dry and sand lightly.
Third Coat (275mm wide)
3. Apply third coat. Feathering 75mm beyond second coat. Let dry and
sand lightly. Finish fastener heads. Corner beads and inside corners as
required with at least three coats of joint compound, feathered out onto
panel faces and finished to a smooth surface.
4. USG Boral Premium Premix compound must be allowed to dry thoroughly
(up to 24 hours depending on temperature and humidity) before re-coating
or sanding.
5. Only apply over setting type compounds that have been allowed to dry
thoroughly.
6. Sand with care using 180 to 220 grit sandpaper.
7. Thoroughly clean all tools and equipment after use.

NOTE: All surfaces including applied joint compound require light sanding
before painting.

gallon (23cm x 23cm x 20cm)
pail (35cm x 35cm x 40cm)

FOR PAYMENT:
(1) Paymongo: Mastercard, VISA, GCash, Maya, Grab Pay
(2) Online Bank Transfer to our BDO, Metrobank, and BPI accountsFor more details, kindly check Accepted Modes of Payment

FOR SHIPPING:
(Customer Location) in Metro Manila (NCR)

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Metro Manila**
Lalamove/ Grab Pin: LPM Construction Supply and Wood Center Corporation

(Customer Location) in Pangasinan

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Pangasinan**
Lalamove/ Grab Pin: LPM Construction Supply PangasinanBrgy, Tayug-San Quintin Rd. Tayug,
Pangasinan, PH